Aiwa CSD-EL300 - Manual (Page 7)

En
E
F
TAPE OPERATIONS
INSERTING A TAPE
Use Type I (normal) tapes only.
Press the TAPE/REV MODE button (or the TAPE
button on the remote control) and press the OPEN
mark to open the cassette holder.
Insert a tape with the exposed side facing forward. Push the
cassette holder to close.
To select a reverse mode
Each time the TAPE/REV MODE (TAPE) button is pressed,
the reverse mode changes.
To play one side only, select P .
To play from front side to back side once only, select .
To play both sides repeatedly, select ] .
PLAYING BACK A TAPE
Insert a tape.
Press the d button (or the c button on the
remote control) to start play.
x : The side facing upward is being played (forward).
c : The opposite side is being played (reverse).
To stop play, press the s button.
To pause play, press the a button. To resume play, press
again.
To change the playback side, press the
d button in play
mode.
To fast forward or rewind, press the
f or g button in
stop mode. Then press the s button to stop the tape.
To start play when the power is off (Direct Play Function)
Press the TAPE/REV MODE (TAPE) button. The power is
turned on and play of the inserted tape begins.
To set the tape counter to 0000
Press the
s button in stop mode.
The counter is also set to 0000 when the cassette holder is
opened.
About cassette tapes
• To prevent accidental erasure, break off the plastic
tabs on the cassette tape with a screwdriver or other
pointed tool after recording.
To record on the tape again, cover the tab openings
with adhesive tape, etc.
• 120-minute or longer tapes are extremely thin and
easily deformed or damaged. They are not
recommended.
• Take up any slack in the tape with a pencil or similar
tool before use. Slack tape may break or jam in the
mechanism.
TAPE PLAYBACK
Playback side of the tape
Tape counter
Side A
Tab for
side A
ENGLISH
7