Alto-Shaam FRYTECH SERIES ASF-75E - Manual (Page 31)

PROGRAMMING THE CONTROL
5. Choose the correct melt cycle for your frying compound. The melt cycle will appear in the LED as
“C L”
or “C S”. “C L” is for liquid frying compounds such as oil and “C S” is for solid frying
compounds such as shortening. Do not choose “C 0”.
• Scroll to change melt cycles by pressing or .
• Press TWICE to accept the new setting and proceed to the lock.
NOTE: Do not press just once and change the “gAS” or “ELEC” setting.
6. Lock or unlock the Control Programming. “LoC” or “ULoC” will appear in the LED display.
“LoC” will prohibit unqualified personnel (without the password) from entering Control
Programming. “ULoC” will leave Control Programming unlocked.
• Scroll to change lock condition by pressing or .
• Press to accept the new setting and proceed to select °F or °C.
7. Select °F or °C for the temperature display. “F” or “C” will appear in the LED display. “F”
will cause the LED to display Fahrenheit. “C” will cause the LED to display Celsius.
• Scroll to change from °F to °C by pressing or .
• Press to accept the new setting and proceed to restart Control Programming sequence or
press and hold for one second to exit Control Programming.
NOTE: At any point in the sequence, pressing and holding for one second will exit Control
Programming.
Electric Fryer Operation & Care Manual • 29
O P E R A T I O N
C A U T I O N
THIS SECTION IS PROVIDED FOR THE ASSISTANCE
OF QUALIFIED SERVICE TECHNICIANS ONLY AND
IS NOT INTENDED FOR USE BY UNTRAINED OR
UNAUTHORIZED SERVICE PERSONNEL.