Allied Telesis AT-S79 - Manual (Page 117)

AT-S79 Management Software User’s Guide
Section I: Using the Menus Interface 117
Resetting a VLAN to the Default Value
To delete all of the Port-based and Tagged VLANs on the switch and
restore the default VLAN with a value of 1, perform the following
procedure.
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 16 on
page 70.
2. From the Advanced Switch Configuration Menu, type V to select VLAN
Management.
The VLAN Management Menu is shown in Figure 23 on page 107.
3. Type V to select 802.1Q VLAN.
The Tagged-based VLAN configuration Menu is shown in Figure 24 on
page 108.
4. Type R to select Reset VLAN to Default.
The following prompt is displayed:
Are you sure you want to reset VLAN configuration to
factory default (Y/N) >
5. Type Y to delete all of the configured VLANs on the switch.
A confirmation message is displayed on the screen.