Allied Telesis AT-S79 - Manual (Page 316)

Chapter 33: 802.1x Port-based Network Access Control
316 Section II: Using the Web Browser Interface
Configuring 802.1x Port-based Network Access Control
To configure 802.1x port-based network access control, perform the
following procedure:
1. From the Security folder, select Port Access Control.
The 802.1x Access Control Configuration page is shown in Figure 93.
Figure 93. 802.1x Access Control Configuration Page
Note
The Initialize and Re-auth Initialize parameters are described in
Steps 5 and 6, respectively.
2. To select a port, do the following:
a. Click Port and select the port you want to configure from the pull-
down menu. You can configure only one port at a time.
b. Click Apply.
The current settings for the selected port are displayed.