Allied Telesis AT-WNP300N - Manual (Page 12)

12 AT-WNP300N - IEEE802.11b/g/n 1T2R Wireless Fast PCI adapter - Installation Guide
1. Switch off your PC, unplug the power cord, and remove the case.
2. Choose an open PCI slot and remove the screw holding the PCI slot cover.
3. Install your wireless adapter and firmly press down on the mounting bracket. Then screw the mounting
bracket, as shown in Figure 2.
Figure 2: Installing Adapter into PC
4.
Locate the antenna connectors on the back of the AT-WNP300N IEEE802.11b/g/n 1T2R Wireless Fast
PCI adapter, as shown in Figure 3.
Figure 3: Location of the Antenna Connectors
5. Screw antennas to connectors, as shown in Figure 3.
Figure 4: Connecting Antennas
You can try repositioning antennas until you get the best signal strength.