Allied Telesis AT-2973T (NetExtreme II) - Manual (Page 104)

Chapter 8: Troubleshooting
104
Troubleshooting Checklist
Caution
Before you open the cabinet of your server to add or remove the
adapter, see “Reviewing Safety Precautions” on page 24.
The following checklist provides recommended actions to resolve
problems installing or running either the AT-2973SX or AT-2973T adapter
in your system.
 Inspect all cables and connections. Verify that the cable connections
at the network adapter and the switch are attached properly. Verify
that the cable length and rating comply with the requirements listed in
“Connecting the Network Cables” on page 33.
 Check the adapter installation by reviewing “Installing a Network
Adapter Card” on page 29. Verify that the adapter is properly seated in
the slot. Check for specific hardware problems, such as obvious
damage to board components or the PCI edge connector.
 Check the configuration settings and change them if they are in conflict
with another device.
 Verify that your server is using the latest BIOS.
 Try inserting the adapter in another slot. If the new position works, the
original slot in your system may be defective.
 Replace the failed adapter with one that is known to work properly. If
the second adapter works in the slot where the first one failed, the
original adapter is probably defective.
 Install the adapter in another functioning system and run the tests
again. If the adapter passed the tests in the new system, the original
system may be defective.
 Remove all other adapters from the system and run the tests again. If
the adapter passes the tests, the other adapters may be causing
contention.
Checking
Current Drivers
This section describes how to check that the current drivers are loaded
properly for the Windows and Linux platforms.
Windows
See “Viewing Vital Signs” in the Broadcom Advanced Control Suite 3 User
Guide to view vital information about the adapter, link status, and network
connectivity.