Allied Telesis AT-2973T (NetExtreme II) - Manual (Page 58)

Chapter 5: Installing the Linux Drivers
58
Load and Run
Necessary iSCSI
Software
Components
Broadcom iSCSI Offload software suite consists of 3 kernel modules and
a user daemon. You can load the required software components either
manually or through system services.
1. Unload existing driver & kill the user daemon if necessary. Do the
following:
Manual:
rmmod bnx2i
pkill -9 bnx2id
Using system service:
service bnx2id stop
2. Load the iSCSI driver and the user daemon. Do the following:
Manual:
bnx2id
insmod bnx2i.ko
or
modprobe bnx2i
Using system service:
service bnx2id start
Unloading the
Linux Driver
You can unload, or remove, the Linux Driver from an RPM or TAR
installation. See the following:
 “Unloading the Driver from an RPM Installation” on page 58
 “Unloading the Driver from a TAR Installation” on page 59
Unloading the Driver from an RPM Installation
This section describes how to unload, or remove, a Linux driver from an
RPM installation.
Note
The examples used in this procedure refer to the bnx2 driver, but
also apply to the bnx2i driver.