Manager and operator accounts, End command – Allied Telesis AT-S63 User Manual
Page 46
Chapter 1: Overview
46
Section I: Basic Operations
END Command
After you configure a feature, you’ll probably want to use the SHOW
commands in the User Exec mode or the Privileged Exec mode to verify
your changes. While you could move back through the modes with the
EXIT command, the END command jumps you directly to the Privileged
Exec mode from any of the lower modes.
Figure 23. Returning to the Privileged Exec Mode with the END Command
Manager and
Operator
Accounts
The AlliedWare Plus interface has a manager access level and an
operator access level. When you log on as a manager, you are given
access to all the modes in the AlliedWare Plus Interface and have full
control over the unit. When you log on as an operator, you are restricted to
the User Exec mode from where you can view parameter settings and
ping other devices.
Privileged
Executive
Mode
User
Executive
Mode
Configure
Terminal
Mode
Multiple
Tree Mode
Spanning
Class-Map
Mode
VLAN
Mode
Interface
Port
Mode
Interface
Line
Mode
Console
Policy Map
Mode
Class
Mode
VLAN
Database
Mode
end