Activate mstp, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 552
Chapter 30: Multiple Spanning Tree Protocol (MSTP) Commands
552
Section V: Spanning Tree Protocols
ACTIVATE MSTP
Syntax
activate mstp
Parameters
None.
Description
This command designates MSTP as the active spanning tree on the
switch. You cannot enable MSTP or configure its parameters until after
you have designated it as the active spanning tree with this command.
Only one spanning tree protocol can be active on the switch at a time.
Example
The following command designates MSTP as the active spanning tree:
activate mstp
AlliedWare Plus
Command
Syntax
spanning-tree mode mstp
Mode
Configure mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree mode mstp
Command
Available
AlliedWare Plus