Allied Telesis AT-S101 - Manual (Page 107)

AT-S101 Management Software User’s Guide
107
Creating a Host Table
Use the following procedure to create a Host Table.
1. From the menu on the left side of the page, select the SNMP folder.
The SNMP folder expands.
2. From the SNMP folder, select Host Table.
The Host Table Page is shown in Figure 32.
Figure 32. Host Table Page
3. To specify an entry number, type a value between 1 and 10 in the
Entry number field.
4. For an SNMP community that you previously defined in the Community
Table page, enter an IP address.
The IP address must be in the xxx.xxx.xxx.xxx format.
5. Select a community name from the pull-down menu next to the
Community Name field. Then click Add.
The new host is added to the table.
6. From the menu on the left side of the page, select Save Configuration
to Flash to save your changes.