Allied Telesis AT-S101 - Manual (Page 59)

AT-S101 Management Software User’s Guide
59
Deleting a Port-Based VLAN
To delete a port-based VLAN, perform the following procedure:
1. From the menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select VLAN.
The VLAN folder expands.
3. From the VLAN folder, select Port-Based VLAN.
The Port-Based VLAN Page is shown in Figure 19 on page 56.
4. In the VLAN Action column, click delete next to the VLAN that you
want to delete.
A confirmation prompt is displayed.
5. Click OK to delete the VLAN or Cancel to cancel the deletion.
Note
You cannot delete the Default VLAN which has a VID of 1.
6. From the menu on the left side of the page, select Save Configuration
to Flash to save your changes.