Allied Telesis 9700 iMAP - Manual (Page 19)

Setup Precautions Install the FAN8
1-13
ATI 9700 - Installation Guide (Initial Installation of the ATI 9700)
1.7 Install the FAN8
1. Remove the FAN8 from its shipping box.
2. Take the FAN8 from its antistatic container.
3. Place it on a table with the front facing the user.
4. Open the lock-latch on each side of the faceplate. This is performed by curling the thumbs of each hand
behind the lock-latch and pressing the release buttons. The lock-latch arms should swing out from the fan
assembly. Refer to
Figure 1-7 , Figure 1-8 , and Figure 1-9 .
FIGURE 1-7 FAN8, arrows indicate latch opening
FIGURE 1-8 Curl thumbs behind lock-latches and press release buttons (right side detail)
FIGURE 1-9 With thumbs, swing the lock-latches open (right side detail)
5. Make sure both left and right lock-latches are fully open.
6. Slide the assembly into its slot on the top of the shelf until it is flush with the shelf surface. Figure 1-10
PULL FAULT INSERV
COMM ALM OUT ALM IN