Allied Telesis AT-2972T/2 - Manual (Page 55)

Advanced Control Suite User’s Guide
55
5. In the list of adapters in the team shown on the left, right-click the
name of the team you want to modify and click Configure Team, Add
VLAN, Configure LiveLink, or Fallback.
6. When you are done with your changes, click Apply.
7. Click Yes when you see the message indicating that the network
connection will be temporarily interrupted.
Adding a VLAN
You also can add VLANs to a team. The concept behind this is that you
are adding multiple virtual adapters that are on different subnets. The
benefit is that your server can have one network adapter that can belong
to multiple subnets. With a VLAN, you can couple the functionality of load
balancing for the Load Balance Members, and you can employ a failover
adapter.
You can define up to 64 VLANs per team (63 tagged and 1 untagged).
VLANs can only be created when all members are Allied Telesis adapters.
If you try to create a VLAN with another type of adapter, an error message
appears.
Note
Disabled adapters are not recognized and they prevent the creation
of a VLAN. If you attempt to create a VLAN with a disabled adapter,
an error message is displayed.
To configure a team with a VLAN, perform the following procedure.
Note
To maintain optimum adapter performance, your system must have
64 MB of system memory for each of the 8 VLANs created per
adapter.
1. Select the team name.
The Team Properties tab opens as shown in Figure 26 on page 50.
2. In the list of adapters in the team shown on the left, right-click the
name of the team you want to modify and click Add VLAN.