Allied Telesis AT-2972T/2 - Manual (Page 56)

Chapter 2: Broadcom Advanced Control Suite 2 (BACS 2) Applications
56
The Add VLAN dialog box opens, as shown inFigure 31
Figure 31. Add VLAN Dialog Box
3. Type the VLAN ID and VLAN name, then click OK.
The Untagged VLAN check box is exclusively used by the VLAN ID
field. To use VLAN ID 0, simply click this check box. If you type a
VLAN name or ID and the name already exists, an Input Error
message appears.
4. When you are finished adding VLANs to this team, click OK.
A new virtual adapter is created for each VLAN.
5. Click Apply.
6. Click Yes when you see the message indicating that the network
connection will be temporarily interrupted.
The available adapters are listed (these adapters are not currently
members of any team).
Displaying VLAN Properties and Statistics and Running VLAN Tests
The procedures in this section describe how to display VLAN properties
and statistics as well as how to run VLAN tests and delete a VLAN.
To display VLAN properties and statistics and to run VLAN tests, perform
the following procedure.
1. In BACS2, click the VLAN name in the team’s Virtual Adapters folder,