Allied Telesis AT-S62 - Manual (Page 559)

AT-S62 Management Software Menus Interface User’s Guide
Section V: VLANs 559
Creating a Port-based or Tagged VLAN
To create a new port-based or tagged VLAN, perform the following
procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 188.
Figure 188. VLAN Configuration Menu
2. From the VLAN Configuration menu, type 4 to select Configure
VLANs.
Note
If option “4 - Configure VLANs” is not displayed in the menu, the
switch is running in a multiple VLAN mode. To change a switch’s
VLAN mode, refer to “Selecting a VLAN Mode” on page 612.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
VLAN Configuration
1 - Ingress Filtering Status ........ Enabled
2 - VLANs Mode ...................... User Configured VLANs
3 - Management VLAN ................. 1 (Default_VLAN)
4 - Configure VLANs
5 - Show VLANs
6 - Show PVIDs
7 - Configure GARP-GVRP
R - Return to Previous Menu
Enter your selection?