Allied Telesis AT-S63 - Manual (Page 321)

321
Chapter 22
GARP VLAN Registration Protocol
Commands
This chapter contains the following commands:
❑ “DISABLE GARP” on page 322
❑ “ENABLE GARP” on page 323
❑ “PURGE GARP” on page 324
❑ “SET GARP PORT” on page 325
❑ “SET GARP TIMER” on page 326
❑ “SHOW GARP” on page 328
❑ “SHOW GARP COUNTER” on page 329
❑ “SHOW GARP DATABASE” on page 331
❑ “SHOW GARP GIP” on page 332
❑ “SHOW GARP MACHINE” on page 333
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
You cannot convert a dynamic GVRP VLAN or port to a static VLAN
or port using the command line interface. That is possible only from
the menus interface. Refer to Chapter 21, “GARP VLAN Registration
Protocol” in the AT-S63 Management Software Menus Interface User’s
Guide for background information on GVRP.