Allied Telesis AT-S39 - Manual (Page 287)

AT-S39 User’s Guide
287
Configuring STP
This section contains the following procedures:
❑ Configuring STP Bridge Settings on page 287
❑ Configuring STP Port Settings on page 289
Configuring STP
Bridge Settings
This section contains the procedure for configuring a bridge’s STP
settings.
Caution
The bridge provides default RSTP parameters that are adequate for
most networks. Changing them without prior experience and an
understanding of how RSTP works might have a negative effect on
your network. You should consult the IEEE 802.1w standard before
changing any of the RSTP parameters.
1. From the Spanning Tree tab menu, click STP Configuration and click
Configure.
The Spanning Tree menu is shown in Figure 88.
Figure 88 STP Bridge Configuration Menu