Allied Telesis AT-S29 - Manual (Page 29)

AT-S29 Management Software User’s Guide
29
Changing the
Network
Configuration
Use the Network Configuration menu to set the bootup option,
configure the switch’s Internet Protocol (IP) parameters, enable the on-
board Web Agent, or enable Telnet access. The screen shown below is
described in the following table.
Parameter Description
IP Configuration Screen used to set the bootup option, or
configure the switch’s IP parameters.
IP Connectivity Test (Ping) Screen used to test IP connectivity to a
specified device.
HTTP Configuration Screen used to enable Web Agent.
MAX Number of Allowed
Telnet Sessions The maximum number of Telnet
sessions allowed to simultaneously
access the agent module.
MAC Address Physical address of the agent module.
Network Configuration
=================
IP Configuration ...
IP Connectivity Test (Ping) ...
HTTP Configuration ...
MAX Number of Allowed Telnet Sessions (1 -4) : 2
MAC Address : 00-30-84-9A-3B-80
<APPLY> <OK> <CANCEL>
Use <TAB> or arrow keys to move. <Enter> to select.