Installing the switch on a desktop – Allied Telesis AT-FS909SX User Manual
Page 19
AT-FS909SX Installation Guide
9
Installing the Switch on a Desktop
1.
Locate a level, secure surface for the switch.
2.
Apply the four rubber feet to the bottom of the switch.
3.
Place the switch on the desktop.
Warning
The power cord is used as a disconnection device. To de-energize
equipment, disconnect the power cord.
!
10
4.
Apply power to the switch by plugging the power cord into the rear of
the unit and plugging the other end into a wall outlet. Verify that the
Power LED lights green.
If the Power LED does not light green, refer to Chapter 3, for further
information.
Warning
Do not stare into the laser beam.
!
7
5.
Connect the data cables and observe normal operation as indicated by
the port LEDs. Refer to Table 1 on page 3 for LED information. For
Port 1, set the MDI Button to the correct setting. Refer to Table 2 on
page 4 for the MDI setting.
6.
Optional: place one of the additional serial number stickers supplied
with your switch on an accessible part of the switch for your
convenient reference.