Switch leds – Allied Telesis AT-8324 User Manual
Page 17
AT-8316F and AT-8324 Quick Install Guide
11
You are now ready to use the Omega management software to configure the
switch. For instructions, refer to the AT-S25 Management Software User’s
Guide. This guide is available on the Allied Telesyn web site at
www.alliedtelesyn.com/techhome.htm.
Switch LEDs
Table 2 and Table 3 describe the functions of the LEDs on the Ethernet
switch.
Table 2 Power and Fault LEDs
LED
State
Description
Fault
Solid Red
The switch or management software is malfunctioning.
Flashing Red
The switch is booting, running diagnostic tests, writing
images to Flash, or transferring files using XMODEM or
TFTP.
OFF
Normal operation.
Master
Solid Amber
The switch is functioning as the master switch of the
stack.
Flashing Amber
The switch is building a topology of the Ethernet stack.
OFF
The switch is installed as a standalone unit or is
functioning as a slave switch in a stack.
RPS (Redundant
Power Supply)
Solid Green
The RPS is connected to the switch. To verify that the
RPS is operating correctly, refer to the instructions in the
RPS Quick Install Guide.
Power
Solid Green
The switch is receiving power, voltage is within the
acceptable range, and the power supply is working.