Allied Telesis AT-8324 - Manual (Page 18)

AT-S25 Software Default Setting
12
Table 3 Port LED Status
For information on troubleshooting the switch, refer to the AT-8316F/MT,
AT-8316F/VF, AT-8316F/SC, and AT-8324 Installation Guide.
AT-S25 Software Default Setting
Table 4 lists the default settings for the AT-S25 software that comes pre-
installed on the Ethernet switch.
Table 4 Ethernet Switch Default Settings
LEDs State Description
L/A (Link/Activity) Solid Green This indicates a 100 Mbps link.
Flashing Green This indicates 100 Mbps activity
Solid Amber This indicates a 10 Mbps link (10/100 ports only).
Flashing Amber This indicates 10 Mbps activity (10/100 Mbps
ports only).
D/C (Duplex/Collision) Solid Green The port is operating at full-duplex.
Solid Amber The port is operating at half-duplex.
Flashing Amber Collisions are occuring on the line.
Settings Default
IP Address 0.0.0.0
Subnet Mask 0.0.0.0
Gateway Address 0.0.0.0
Get community string public
Set community string private
Trap community string public
Spanning Tree Protocol Disabled
Bridge Priority 32768
Max Age Time 20
Hello time 2
Forwarding Delay 15