Hubbardton Forge 134328 - Manual (Page 2)

Assembly & Installation Instructions
A87
For Oval Mackintosh Pendant 13-4325 & 13-4328 Page 2 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 19399 Rev A
Assemble Fixture (Figures 3 & 4)
Components
I Canopy
J Canopy pipe
K Clutch sleeve
L Set screw
M Clutch
N Fixture pipe
1. Slip the wires from the fixture pipe (N) into and through the canopy pipe (J)
up through the canopy (I).
2. Unscrew the clutch (M) from the canopy pipe (K); slide it across the wires
and onto the fixture pipe (N). Follow this with the plastic clutch sleeve (K),
oriented so the tapered end of the clutch sleeve nests in the clutch.
3. Slide the canopy pipe (J) as far as necessary to give you the total length of
the fixture which you desire. Be careful not to scratch the pipe surfaces and
to pull excess wire up through the canopy pipe (J). There must be a minimum
1-1/2" of inner pipe inside the outer pipe. Screw clutch onto canopy pipe (J)
and hand-tighten the clutch to temporarily hold this adjustment. The clutch is
not securely fastened at this point; do not depend on it to hold the fixture.
Important: To ensure full connection strength, be sure the tapered end of
the plastic clutch sleeve is oriented toward the clutch when assembled and
securely tighten set screw
(Figure 4).
4. Stop. Please see installation instructions below.
5. Once the fixture is fastened to the ceiling, tighten the set screw (L) firmly
with hex wrench provided. Only after the set screw is tight should you install
the glass.
Note: If your fixture has more than one set of pipes or stems in the canopy
you will need to level the fixture. While always leaving one clutch firmly
locked with the set screw, loosen the other(s). Raise or lower the pipe(s) in
the other clutch to obtain plum and level and then tighten the set screw(s).
(continued)
(Figure 3)
(Figure 4)