Hubbardton Forge 134328 - Manual (Page 3)

Assembly & Installation Instructions
A87
For Oval Mackintosh Pendant 13-4325 & 13-4328 Page 3 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 19399 Rev A
For fixtures requiring assembly, please refer to assembly instructions before installation.
Install Fixture (Figure 5)
Component Parts
I Canopy
O Crossbar
P Threaded stud (2)
Q Ground screw
R Knurled ball (2)
Caution: Be sure power is off at the main breaker box prior to installation.
1. Thread studs (P) through appropriate holes in the crossbar (O) to match
hole centers on canopy (I). Move ground screw (P) to another available
threaded hole if necessary.
2. Using two machine screws (not provided), fasten the crossbar (O) to the
electric box using outer oval slots to orient fixture to desired hanging
position.
Note: A new electric box comes with screws. When replacing a fixture,
retain the existing screws for use with the new fixture.
4. Using suitable wire connectors (not provided) connect fixture wires to
supply (white to white and black to black ). Connect all ground wires to
green ground screw (Q).
Caution: Make sure wire connectors are twisted on securely, and no
bare wire is exposed.
5. Slide fixture canopy (I) with fixture attached, over threaded studs (P) and
push firmly to ceiling making sure that no wires are pinched between
fixture canopy and ceiling. Fasten with the knurled balls (R). Be sure
studs (P) are fully seated in the knurled balls (R).
6. Check fixture for height and level (see assembly instructions).
7. Install light bulbs (not included).
8. Install Glass by tilting it, sliding it into place and leveling it. Glass rests on lower ring with no hardware.
9. Restore electricity at main breaker box.
A Note about Oval Glass
Slight variations in the oval glass shape are normal. This is a kiln-formed glass that goes through a dynamic stretching
and pulling process that simpler shapes do not. To make the oval, the artisan heats the flat glass to over 1,200 degrees and
then uses gravity to form it into a deep curve. Each piece of glass is unique, and slight variations in shape are a normal
result of this process.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 5)