Blodgett DFG-100 XCEL - Manual (Page 20)

18
Operation
SSD - Solid State Digital Control
PRoGRAMMinG
to set the cook temperature:
1. Press TEMP (7) key.
2. Rotate dial (6) to enter temperature.
to set the cook time:
1. Press TIME (8) key.
2. Rotate the dial (6) to enter time.
NOTE: Time is entered in hours:minutes (0:00) or
minutes:seconds (00:00).
to set the hold time:
1. Press HOLD key (11) to turn hold mode on.
NOTE: HOLD light is on.
2. Rotate dial (6) to enter the hold temperature.
3. Press START/STOP key (12)
to set the pulse time:
1. Press PULSE KEY (9) to turn pulse mode on.
NOTE: Pulse light is on.
2. Rotate DIAL (6) to enter the pulse time. Pulse time is
a portion of the pre-set cook time.
oPERAtion
Cook only:
1. Turn the SELECTOR switch (1) to the desired posi-
tion. If high fan is chosen, high rate may be selected
by toggling the RATE SWITCH (14).
2. Enter the cook time and temperature.
3. Load product into the oven.
NOTE: The display reads LOAD when the oven is
near the set temperature.
4. Press the START/STOP key (12). The timer begins
to count down.
5. When the cook timer reaches 00:00 the buzzer
sounds and the display reads DONE.
6. Press the START/STOP key (12) to silence the buzz-
er.
7. Remove the product.
Cook with hold:
NOTE: HOLD light is on when hold mode is on and off
when hold mode is off.
1. Turn the SELECTOR switch (1) to the desired posi-
tion. If high fan is chosen, high rate may be selected
by toggling the RATE SWITCH (14).
2. Enter the cook time and temperature.
3. Press the HOLD key (11). Enter the hold temperature.
4. Load product into the oven.
NOTE: The display reads LOAD when the oven is
near the set temperature.
5. Push the START/STOP (12) key. Timer begins to
count down.
6. When the cook timer reaches 00:00 the buzzer sounds
and the display reads DONE. The buzzer turns off af-
ter a few seconds. The display reads HOLD until the
oven reaches the hold temperature. Then the timer
begins to count up.
7. Push the START/STOP key (12) to stop timer.
8. Remove the product.
9. Push HOLD (11) key to turn off hold mode.