Draining the unit – NewAir PORTABLE AIR CONDITIONER AC 12000E User Manual
Page 10
DRAINING THE UNIT
During the cooling process, some water will be extracted from the air and stored within
the unit’s water reservoir.
If the water reservoir is full, both the compressor and motor will stop and the unit will
beep (press any button to stop the beeping sound). The full water tank indicator light
will also start flashing.
To resume cooling, empty the reservoir by following these steps:
1. Turn off the air conditioner and unplug it
from the wall socket. To prevent water
leakage, avoid moving the unit when full.
2. Place a container (such as a small pan)
underneath the hole.
3.
Remove the rubber plug from the hole
and allow the water to drain out.
4.
When the container is almost full, replace
the plug back into the hole.
5.
Repeat these steps until the water
reservoir is completely empty.
6. Replace the rubber plug and make sure it
is firmly in place.
7. Turn the unit back on. The full tank
indicator light should turn off.
9
Water hole
Rubber plug
Drain knob
FIG.14
k0045