Hydraulic installation – Swiftech H20 220 T User Manual
Page 18
Part # AJ00264 backing plate alone
Part # AJ00172 complete retention frame & backing plate
Figure 6
Figure 7
Remove the peel-off paper back from the motherboard gasket,
and install it as shown above. The sticky side should be towards
the motherboard.
Insert the processor into the socket.
Since you have grease inside the socket, some hydraulic
pressure lift may occur: for this reason, make sure that the
processor sits perfectly flat, and is inserted all the way into the
socket. Then, drop a small amount of high quality thermal
compound into the center of the processor core.
Figure 8
Figure 9
Place the stock plastic retention over the gasket as shown above
Secure the MCW5002-64T cooler to the motherboard by
alternatively and gradually tightening the 2 retention screws.
IMPORTANT WARNING: Solder joints of the wires to the thermoelectric module are extremely fragile. Bending the wires
at their root will break the solder joint, with no possible repair. Swiftech will not honor the warranty for broken
C. Hydraulic Installation
The MCW5002-T is shipped with ½” barb to 3/8” NPT nylon fittings. These fittings should be installed using
Teflon tape or plumbers “goop”. If fittings need to be replaced for a difference tubing size, do not use brass fittings,
because of the galvanic corrosion that will take place between copper or brass and the MCW5002-T aluminum
housing. Always use nylon fittings.
Copyright Swiftech 2005 – All rights reserved – Last revision date: 12-27-05 - Information subject to change without notice – URL:
http://www.swiftnets.com
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail: [email protected]
PAGE 18 of 32
Inlet and outlet are interchangeable.