Axis Communications LBP 5200 - Manual (Page 310)

Installing the Network Board (AXIS 1611) 6-15
Optional Accessor
ies
6
1
Press the power switch to turn the printer off a a a a, remove the
USB cable b b b b, and disconnect the power plug from the power
outlet c c c c.
2
Remove all the interface cables and the power cord from the
printer.
If there is not enough space to install the network board, move the printer to a
place where it is easier to work.
3
Remove the 2 screws from the top and bottom sections of the
expansion board slot, and then remove the protective plate.
IMPORTANT
You will need the screws that you removed to attach the network board. You will
also need the protective plate if you remove the network board. Store these parts
and do not discard them.
a
b
c