Axis Communications LBP 5200 - Manual (Page 354)

Paper Problems 7-39
T
roub
leshooting
7
Cause 4 The paper is too thin.
Remedy 1 Set the [Paper Type] in the printer driver to [Plain Paper].
Open the [Paper Source] sheet to change the [Paper Type] setting.
Remedy 2 Set the [Special Print Mode] in the printer driver to [Special Settings 6]. If this
solves the problem, set the [Special Print Mode] back to [Off].
Update the [Special Print Mode] in the [Finishing Details] dialog box by clicking
[Finishing Details] in the [Finishing] sheet.
White dust is attached to the printed transparencies.
Cause The transparencies were printed just after another type of paper was printed
continuously.
Remedy If you print transparencies after printing continuously on normal paper, paper
dust may adhere to the transparencies when they are output. If this is the case,
use a soft cloth to wipe off the paper dust.