PerTronix Ignitor II 91285LS - Manual

440 E. Arrow Highway, San Dimas, CA. 91773
909-599-5955 www.pertronix.com
LIMITED WARRANTY
Pertronix, Inc. Warrants to the original Purchaser of its solid-state ignition system (product) that the
Ignitor, magnet assembly and wiring (components) shall be free from defects in material and workmanship for a
period of (30) months from the date of purchase.
If within the period of the foregoing warranty Pertronix finds, after inspection, that the product or any
component thereof is defective, Pertronix will, at its option, repair such products or component or replace them
with identical or similar parts PROVIDED that within such period Purchaser:
1. Promptly Notifies Pertonix, in writing, of such defects.
2. Delivers the defective products product or component to Pertronix (ATTN: Warranty) with proof of purchase
date; and
3. Has installed and used the product in a normal and Proper manner, consistent with Pertronix printed
instructions.
THE FORGOING LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES,
WHETHER EXPRESSED OR IMPLIED, INCLUDING AND IMPLIED WARRANTY OR MERCHANTABILITY OR
FITNESS FOR A PURPOSE.
THE FURNISHING OF A REPAIR OR REPLACEMENT COMPONENTS SHALL CONSTITUTE THE SOLE
REMEDY OF PURCHASER AND THE SOLE LIABILITY OF PerTronix WHETHER ON WARRANTY, CONTRACT
OR FOR NEGLIGENCE, AND IN NO EVENT WILL PerTronix BE LIABLE FOR MONEY DAMAGES WHETHER
DIRECT OR CONSEQUENTIAL.
12-VOLT NEGATIVE GROUND INSTRUCTIONS
GENERAL INFORMATION
1. IMPORTANT: Read all instructions before starting installation.
2. DO NOT USE WITH SOLID CORE SPARK PLUG WIRES.
3. The Lobe sensor Ignitor II is designed specifically for the application and distributor
numbers that are listed in the application guide. Any modification to this component
will void the warranty.
4. The Lobe Sensor Ignitor II does not require a magnet sleeve to trigger the module.
5. The Ignitor II ignition can be used in conjunction with most ignition coils rated at
0.45 ohms or greater.
6. All external resistors must be removed to achieve optimum performance from the
Ignitor II ignition system.
7. The Ignitor II is compatible as a trigger for most electronic boxes.
8. See our website (www.pertronix.com) for the latest product information.
FOR PART NUMBER: 91285LS
DISTRIBUTOR DISASSEMBLY
1. PRIOR TO INSTALLATION TURN IGNITION SWITCH OFF OR DISCONNECT
THE BATTERY.
2. Remove distributor cap and rotor from distributor. Do not disconnect spark plug
wires from cap.
3. Examine cap and rotor for wear or damage. Replace as needed.
4. Remove point wire and terminal from distributor.
5. Remove the breaker plate retaining ring.
6. Remove the timing adjustment screw and indicator.
7. Remove the complete breaker plate assembly from the distributor housing.
8. Clean all dirt and excess oil from the breaker plate and point cam.
IGNITOR INSTALLATION
9. Install the Ignitor II plate into the distributor housing.
10. Align the mounting hole with the timing slot in the distributor housing.
11. Install timing adjustment screw and indicator. DO NOT TIGHTEN AT THIS TIME.
12. Install
the breaker plate retaining ring.
13. Insert wires through hole in the distributor housing and pull wire grommet into
place. CAUTION: Care must be taken to insure wires do not interfere with moving
parts.
14. Tighten the timing adjustment screw.