PerTronix Ignitor II 9LU-1122A - Manual

440 E. Arrow Highway, San Dimas, CA. 91773
909-599-5955 www.pertronix.com
LIMITED WARRANTY
Pertronix, Inc. Warrants to the original Purchaser of its solid-state ignition system (product) that the
Ignitor, magnet assembly and wiring (components) shall be free from defects in material and workmanship for a
period of (30) months from the date of purchase.
If within the period of the foregoing warranty Pertronix finds, after inspection, that the product or any
component thereof is defective, Pertronix will, at its option, repair such products or component or replace them
with identical or similar parts PROVIDED that within such period Purchaser:
1. Promptly Notifies Pertronix, in writing, of such defects.
2. Delivers the defective products product or component to Pertronix (ATTN: Warranty) with proof of purchase
date; and
3. Has installed and used the product in a normal and Proper manner, consistent with Pertronix printed
instructions.
THE FORGOING LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER
WARRANTIES, WHETHER EXPRESSED OR IMPLIED, INCLUDING AND IMPLIED WARRANTY OR
MERCHANTABILITY OR FITNESS FOR A PURPOSE.
THE FURNISHING OF A REPAIR OR REPLACEMENT COMPONENTS SHALL CONSTITUTE THE SOLE
REMEDY OF PURCHASER AND THE SOLE LIABILITY OF PerTronix WHETHER ON WARRANTY, CONTRACT
OR FOR NEGLIGENCE, AND IN NO EVENT WILL PerTronix BE LIABLE FOR MONEY DAMAGES WHETHER
DIRECT OR CONSEQUENTIAL.
12-VOLT NEGATIVE GROUND INSTRUCTIONS
GENERAL INFORMATION
1. See our website (www.pertronix.com) for the latest product information.
2. IMPORTANT: Read all instructions before starting installation.
3. WARNING!!! DO NOT USE WITH SOLID CORE IGNITION WIRES.
4. The Ignitor II ignition can be used in conjunction with most ignition coils rated at 0.45 ohms or
greater.
5. All external resistors must be removed to achieve optimum performance from the Ignitor II ignition
system.
6. The Ignitor II is compatible as a trigger for most electronic boxes.
IGNITOR INSTALLATION
1. Turn the ignitionswitch off and disconnect the battery
negative (-) cable.
2. Disconnect the distributor harness from the ignition
amplifier. Disconnect and remove the amplifier from the
vehicle.
3. Remove the distributor cap without disconnecting the
spark plug wires.
4. Remove the distributor rotor.
5. Remove the c-clip and plastic trigger wheel.
6. Remove the tension spring from the plastic vacuum
plate. Remove the vacuum plate and module from the
distributor. (See Illustration A).
7. Clean the inside of the distributor housing and distributor
shaft.
8. Install the new black plastic vacuum plate into the
distributor. Work the vacuum plate over the center
distributor hub. Lift the vacuum arm onto the plastic
advance plate pin. (See Illustration B).
9. Install the tension spring into the new plastic advance
plate.
10. Place the Ignitor module and plate into position. The
module should ne positioned over the vacuum advance
arm.
For Part Numbers: 9LU-1122A