PerTronix Ignitor II 9LU-181A - Manual (Page 2)

WHITE WIRE ENGINE GROUND
WHITE WIRE ENGINE GROUND
FIGURE
1
WIRING
DIA
GRAM
IGNIT
OR
SYSTEM
WITHOUT
BALLAST
RESIST
OR
FIGURE
2
WIRING
DIA
GRAM
IGNIT
OR
SYSTEM
WITH
BALLAST
RESIST
OR
NO
TE:
A
RESIST
OR
WIRE
OR
BALLAST
RESIST
OR
MA
Y
OR
MA
Y
NO
T
BE
INCLUDED
IN
THE
ORIGINAL
EQ
UIPMENT
.
WIRING INSTRUCTIONS
1. Connect the Ignitor black wire to the negative (-) side of the ignition coil.
2. For installations that do not use a primary ballast resistor, connect the Ignitor
red wire to the positive (+) side of the ignition coil. (See Figure 1)
3. For installations that use a primary ballast resistor, connect the red wire to
the ignition switch side of the resistor. (See Figure 2).
4. Reconnect battery and make sure all wires are connected properly.
5. The engine can now be started. Let the engine run for a few minutes and
then set the timing in the conventional manner.