PerTronix JBA Exhaust 1400S - Manual (Page 4)

LIMITED ONE YEAR WARRANTY
All JBA HEADERS and exhaust products are guaranteed, to the original purchaser, to be free of defects in materials and
workmanship for one year. This warranty covers the replacement or repair of the product only and does not cover the cost
of removal and installation, customer applied aftermarket coatings or any discoloration or corrosion of finished surfaces.
Damage or product failure resulting from collision, improper installation, off-road use, road hazards, the use of exhaust
insulating wrap or like products or rust occurring after installation, is not covered by the warranty. The warranty extends
only to the original purchaser.
Should a part become defective it should be returned to the original selling retailer and must be accompanied with the
sales receipt. If there is no retailer in your area, call the factory for a return authorization and return your part prepaid to
the factory for inspection. PerTronix reserves the rights to replace or repair the alleged defective part and return the part
freight collect.
Passenger Side:
1. Remove the engine oil dipstick tube by unbolting from the engine and then pulling and wiggling the tube out
of the boss.
2. Repeat steps 2 through 18 to install the passenger side header.
3. Reinstall the oil dipstick tube and bolt it to the engine.
4. Lower the engine and reinstall the motor mount bolts securely
5. Bolt the exhaust to the catalytic convertors
6. Check that all bolts are tight. Make sure that all wiring, fuel lines, transmissions lines, brake lines etc are
clear of the headers and the exhaust and relocate as necessary.
7. Reconnect the negative battery cable.
8. Start the engine, check for leaks and test drive. Then let the engine cool and then re-torque the header bolts.
9. After 100 miles check and retighten the header bol
Parts List:
(1) Driver Side Header Assembly
(1) Passenger Side Header Assembly
(2) Header gaskets (Header to Head flange)