PerTronix JBA Exhaust 1841S - Manual (Page 4)

LIMITED ONE YEAR WARRANTY
All JBA HEADERS and exhaust products are guaranteed, to the original purchas-
er, to be free of defects in materials and workmanship for one year. This warranty
covers the replacement or repair of the product only and does not cover the cost
of removal and installation, customer applied aftermarket coatings or any discolor-
ation or corrosion of finished surfaces.
Damage or product failure resulting from collision, improper installation, off-road
use, road hazards, the use of exhaust insulating wrap or like products or rust oc-
curring after installation, is not covered by the warranty. The warranty extends only
to the original purchaser.
Should a part become defective it should be returned to the original selling retailer
and must be accompanied with the sales receipt. If there is no retailer in your area,
call the factory for a return authorization and return your part prepaid to the factory
for inspection. PerTronix reserves the rights to replace or repair the alleged defec-
tive part and return the part freight collect.
Parts List:
(1) Driver’s Side Header Assembly
(6) Collector Bolts, Nuts &Washers.
(1) Passenger’s Side Header Assembly (4) 1/4”I.D. x 1/2” long spacer
(11) 3/8” x 1”header bolts & lock washers (4) 1/4”x 1” bolts
(2) Header gaskets (1) Heat Riser Tube Adapter.
(1) 3/8” I.D. x 1” long spacer (1) Plug for the O2 sensor fitting
(2) 90 degree spark plug boots (2) Spark plug wire terminals
13. As with the driver’s side, apply anti-seize to the bolts, apply silicone to the dome flange, and bolt the headers to the head and the
exhaust system. Reattach the spark plug looms in the same manner as the driver’s side.
14. If retaining the heat riser, clamp the supplied heat riser adapter to the header using the supplied hose clamp. Shorten flexible heat
riser tube to fit (about 3-1/2 inches). Take care not to cut the tube too short.
15. Recheck everything!
16. Start engine and let it warm up. Check for leaks. Shut engine off and let it cool down. Check to make sure all fasteners are tight.
17. Periodically check and retighten the header bolts.