PerTronix JBA Exhaust 6818S - Manual (Page 4)

LIMITED ONE YEAR WARRANTY
All JBA HEADERS and exhaust products are guaranteed, to the original purchas-
er, to be free of defects in materials and workmanship for one year. This warranty
covers the replacement or repair of the product only and does not cover the cost
of removal and installation, customer applied aftermarket coatings or any discolor-
ation or corrosion of finished surfaces.
Damage or product failure resulting from collision, improper installation, off-road
use, road hazards, the use of exhaust insulating wrap or like products or rust oc-
curring after installation, is not covered by the warranty. The warranty extends only
to the original purchaser.
Should a part become defective it should be returned to the original selling retailer
and must be accompanied with the sales receipt. If there is no retailer in your area,
call the factory for a return authorization and return your part prepaid to the factory
for inspection. PerTronix reserves the rights to replace or repair the alleged defec-
tive part and return the part freight collect.
Parts List:
(1) Driver’s Side Header Assembly
(1) Passenger’s Side Header Assembly
(12) 8mm - 1.25 x 25mm Header bolts (Torque to 13 lbs./in on aluminum heads)
(2) Header gaskets
(2) Air tube gaskets
(4) 8mm - 125x25 bolts for AIR tube
INSTALLATION NOTE FOR O2 SENSORS
1997-03 Corvettes use a flat connector on the O2 Sensor. it is generally agreed that this is a problem-
atic type of O2 sensor. It is recommended that 97-03 owners mover the rear O2 sensor to the front
position and shut off the rears in the computer. Optionally you can get an extension for the flat type
from Casper Electronics, part #109013. For all cars that use the Square tpye O2 sensor, you will pos-
sibly need 2 extensions, JBA part #6611W.