PerTronix Dougs Headers D303Y-SP User Manual

Application, Disassembly

Advertising
background image

Part No. 0110-003001

Page 1

rev 8-15-11 DSL

HEADER INSTALLATION INSTRUCTIONS

D303Y, D303Y-DP & D303Y-SP

APPLICATION

1968-1987 Chevrolet/GMC ½, ¾ & 1 Ton 2&4 WD Pickup

1975-1991 Chevrolet P30 Motorhome


PerTronix

©

thanks you for choosing

DOUG’S HEADERS, the best fitting, highest quality header on the market. In order to

realize the full potential of our good fit, please read and understand these instructions completely prior to starting work.

CHECK TO MAKE SURE YOU RECEIVED THE PROPER PARTS FOR YOUR APPLICATION. THE HEADER NUMBER WILL BE
STAMPED ON THE ENGINE FLANGE. IF YOU ARE UNSURE YOU HAVE RECEIVED THE PROPER PARTS CALL BEFORE
YOU START WORK.

BE SURE TO WORK SAFE! WHENEVER YOU WORK UNDER THE VEHICLE BE SURE THAT IT IS LOCATED ON LEVEL,
SOLID GROUND AND IS SUPPORTED BY ADEQUATE SAFETY STANDS!
REMEMBER: HOT ASPHALT WILL NOT SUPPORT MOST JACK STANDS!

Many factors affect the installation of headers, some of which are broken or aftermarket motor mounts, accidents that impact the
configuration of the frame, and/or the installation of different engines or aftermarket cylinder heads. Most installations require some
welding. If you are uncomfortable with welding operations, we recommend that you contact a professional exhaust system
specialist to install your new headers.

Attention Customers breaking in new engines
: Due to the extreme heat generated during the break-in process, the appearance
of the ceramic coating may be altered in certain areas. The protection characteristics and thermal barrier properties of the coating is
never compromised. It is recommended that a cast iron manifold or old set of headers be used for this process.

Notice
: The coating of these headers can be marred or scratched during installation. If the header needs to be returned and is
damaged, you will be charged for recoat.

DISASSEMBLY

1. Disconnect the negative battery cable from the battery.
2. If a car lift is not available, raise the vehicle 2 feet or higher and support it with adequate

safety stands. Make sure the vehicle is on a flat solid surface and is stable.

3. Apply penetrating oil to all nuts and bolts to be removed.
4. Remove and mark all spark plug wires and then remove all spark plugs.

NOTE: Grasp the spark plug boot, not the wire, and use a twisting motion while pulling the
wire from the plug.

5. Disconnect the head pipes from the exhaust manifolds and remove the manifolds.

Depending on your application, you may be required to remove the alternator, dipstick,
clutch linkage, and/or oil filter. In some cases it may be necessary to remove the starter and
power steering unit. Only remove what is necessary to allow the removal of the manifolds
or the installation of the new headers.

Corporate Office: PerTronix Inc. 440 E. Arrow Highway, San Dimas, California 91773 * Phone 909.599.5955 * FAX 909.599.6424 * www.dougsheaders.com

Advertising
This manual is related to the following products: