PerTronix Dougs Headers D332 - Manual (Page 3)

0110-003109 Page 3 of 3 8-15-2011 DSL
START THE ENGINE
Start the engine and allow it to warm up to operating temperature. Check for any unusual noises
or exhaust leaks. If everything is OK, stop the engine and tighten all bolts while the engine is still
warm. NOTE: Check the bolts periodically to make sure they have not loosened. Re-tighten after
the first 500 miles and then again at 1000 miles
IMPORTANT CHECK LIST
Be sure that all brake lines and fuel lines are clear of headers and/or connector pipes.
All spark plug wires, battery cables, or other electrical components should be clear of
headers and/or connector pipes.
If dipstick tube was removed, make sure it is installed properly and that the dipstick has
been replaced.
Double-check the tightness of all bolts including brackets and accessories.
PARTS LIST
Qty Description
1 Left Side Header
1 Right Side Header
2 Header Gaskets
2 3 ½” Reducers
2
3 ½”, 3 Bolt Collector Gaskets
16 3/8”-16 X 1” Header Bolts
24
3/8” Header Star Washers
6 3/8”-16 X 1 ¼” Hex Head Cap Screws
6
3/8”-16 Hex Nuts