PerTronix Dougs Headers D3399Y-2SP - Manual (Page 4)

Part No. 0110-003026
Page 4
Rev. 2 3-5-13 DSL
START THE ENGINE
Start the engine and allow it to warm up to operating temperature. Check for any unusual noises or exhaust leaks.
If every thing is OK, stop the engine and tighten all bolts while the engine is still warm.
NOTE: Check the bolts periodically to make sure they have not loosened. Re-tighten after the first 500 miles and
then again at 1000 miles.
IMPORTANT CHECK LIST
Be sure that all brake lines and fuel lines are clear of headers and/or connector pipes.
All spark plug wires, battery cables, or other electrical components should be clear of headers
and/or connector pipes.
If dipstick tube was removed, make sure it is installed properly and that the dipstick has been
replaced.
Double-check the tightness of all bolts including brackets and accessories.
PARTS LIST
Qty. Description
1 Right side header
1 Left side header
1 Right side connector pipe
1 Left side connector pipe
2 Header gaskets
2 2 ½” Metal donut gaskets
1
3” Collector gasket
1 Decal:
DOUG’S HEADERS
1 Sticker, C.A.R.B., E.O., D-57-19
1 Hardware kit:
16
3/8”-16 x 1 ¼” header bolts
6 3/8”-16 x 2 ¼” hex bolts
9
3/8”-16 hex nuts
9 3/8” lock-washers
3
3/8” -16 x 1 ¼” hex head cap screw