PerTronix Dougs Headers D6672 - Manual (Page 3)

Part No. 0110-003060
Page 3
12-19-06 sak
START THE ENGINE
Start the engine and allow it to warm up to operating temperature.
Caution! Hot parts! Wear protective clothing as needed.
Check for any unusual noises or exhaust leaks. If every thing is OK, stop the engine and
tighten all bolts while the engine is still warm.
NOTE: Check the bolts periodically to make sure they have not loosened. Re-tighten after the
first 500 miles and then again at 1000 miles.
PARTS LIST
Qty. Description
1 Right side header
1 Left side header
2 Inner flanges
4 Header / inner flange gaskets
2 Collector gaskets
2 Reducers
1 Decal:
DOUG’S HEADERS
1 Hardware kit:
16
5/16”-18 x 3/4” flanged header bolts
16 3/8”-16 x ½” Allen flathead countersunk screws
16 5/16
” lock washers
6 3/8” lock washers
6 3/8”-16 x 1-1/4” hex bolts
6
3/8” hex nuts
Trim off corner
as indicated
RIGHT SIDE MOTOR MOUNT
Figure 1