PerTronix Dougs Headers D920 - Manual

Part No. 0110-003040
Page 1
Rev.1 11-19-13 DSL
Y-PIPE INSTALLATION INSTRUCTIONS
D920
1993-1997 CAMARO, LT1 USING DOUGS HEADER D3324
PerTronix
©
thanks you for choosing
DOUG’S HEADERS
, the best fitting, highest quality header on the
market. In order to realize the full potential of our good fit, please read and understand these instructions
completely prior to starting work.
CHECK TO MAKE SURE YOU RECEIVED THE PROPER PARTS FOR YOUR APPLICATION. IF YOU ARE UNSURE YOU
HAVE RECEIVED THE PROPER PARTS CALL BEFORE YOU START WORK.
BE SURE TO WORK SAFE! WHENEVER YOU WORK UNDER THE VEHICLE BE SURE THAT IT IS LOCATED ON LEVEL,
SOLID GROUND AND IS SUPPORTED BY ADEQUATE SAFETY STANDS!
REMEMBER: HOT ASPHALT WILL NOT SUPPORT MOST JACK STANDS!
Many factors affect the installation of headers and y-pipes, some of which are broken or aftermarket motor mounts,
accidents that impact the configuration of the frame, and/or the installation of different engines or aftermarket
cylinder heads. Most installations require some welding. If you are uncomfortable with welding operations, we
recommend that you contact a professional exhaust system specialist to install your new Y-Pipe.
BEFORE STARTING
We recommend welding all pipe slip joints. If no welding equipment is available at the
time of installation, use the furnished clamps to secure the pipes until they can be
welded.
This Y-
Pipe is designed to fit with Doug’s Header Part No. D3324 only!
This Y-Pipe will bolt to a stock catalytic converter.
DISASSEMBLY
1. Disconnect the negative battery cable from the battery.
2. If a car lift is not available, raise the vehicle 2 feet or higher and support it with
adequate safety stands. Make sure the vehicle is on a flat solid surface and is stable.
3. Remove the under driveshaft cross-member.
4. Remove exhaust system forward of the catalytic converter.
Corporate Office: PerTronix Inc. 440 E. Arrow Highway, San Dimas, California 91773 * Phone 909.599.5955 * FAX 909.599.6424 * www.dougsheaders.com