Nikon MB-D14 - Manual (Page 22)

6
En
Using the Battery Pack
Attaching the Battery Pack Attaching the Battery Pack
Before attaching the battery pack, be sure that the camera is off and that the MB-D14
control lock (Figure A-
!4 ) is in the L position (the illustrations show the D600).
1 Remove the contact cap (Figure A- q ) from the battery pack.
2 The contacts for the MB-D14 are in the base of the camera, where they are pro-
tected by a contact cover. Remove the contact cover as shown in Figure B- q and
place it in the contact cover holder on the MB-D14 (Figure B- w ).
3 Position the MB-D14, keeping the MB-D14 mounting screw (Figure C- w ) aligned
with the camera tripod socket (Figure C- q ) and tighten the attachment wheel by
rotating it in the direction shown by the LOCK arrow (Figure D). There is no need
to remove the battery from the camera before connecting the MB-D14. At default
settings, the battery inserted in the camera will be used only after the battery in the
MB-D14 is exhausted. The Battery order option in the camera Custom Settings
menu (Group d) can be used to change the order in which the batteries are used.
Be sure to place the camera contact cover in the contact cover holder and to keep
the MB-D14 contact cap in a safe place to prevent loss.
A PB-6D and PK-13 auto-extension ring are required when using PB-6 bellows fo-
cusing attachment with the MB-D14.
Removing the Battery Pack Removing the Battery Pack
To remove the MB-D14, turn the cam-
era off and set the control lock on the
MB-D14 to L, then loosen the attachment
wheel and remove the MB-D14. Be sure
to replace the contact cover on the cam-
era and the contact cap on the MB-D14
when the battery pack is not in use.