Aga Ranges U104601-01 - Manual (Page 33)

33
Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
Location guidelines
Do not locate the range where it may be subject
to strong drafts. Any openings in the fl oor or wall
behind the range should be sealed. Make sure
the openings around the base of the range that
supply fresh air for combustion and ventilation
are not obstructed by carpeting or woodwork.
Your range is heavy and can settle into soft fl oor
coverings such as cushioned vinyl or carpeting.
Use care when moving the range on this type
of fl ooring. It is recommended that the following
simple and inexpensive instructions be followed
to protect your fl oor.
The range should be installed on a sheet of
plywood (or similar material). When the fl oor
covering ends at the front of the range, the area
that the range will rest on should be built up with
plywood to the same level or higher than the
fl oor covering.
This will allow the range to be moved for
cleaning or servicing. Also, make sure your
fl oor covering will withstand 180°F. (See the
Installation Safety Instructions section.)
Make sure the wall coverings around your
range can withstand the heat generated (up to
200°F) by the range. (See the Installation Safety
Instructions section.)
Moving the Range
The range is very heavy. Take great care.
We recommend two people maneuver the range.
Ensure that the fl oor covering is fi rmly attached,
or removed to prevent it being disturbed when
moving the range around. You will need the
leveling tool.
From the back tilt the range forward and remove
the rear half of the polystyrene base pack.
Repeat from the front and remove the front half
of the polystyrene base.
LOWER THE TWO REAR ROLLERS.
First fi t the levelling tool on the hexagonal
adjusting nut as shown below.
Make 10 complete (360º) turns clockwise. (This
means turning and removing the levelling tool 20
times).
Make sure you lower BOTH REAR ROLLERS.
There are two adjusting nuts, one for each roller,
at both the front bottom corners of the range.
Note the rollers are only intended to aid
installation - the range should not be
moved once it is installed.
Unfold the rear edge of pack base tray. Open the
grill door and the Tall oven door. Grip under the
control panel and lift the front of the range.