Aga Ranges U104601-01 - Manual (Page 45)

SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check ap pli ance is safe when you have finished.
45
Gas Regulator
Remove the fl ue grille and splash assembly from
the rear of the range by removing the two fi xing
screws.
The regulator is now accessible. Unscrew the
brass top of the regulator.
In the base of the brass top is a plastic snap in
converter device.
Natural gas Propane gas
To convert the regulator snap the device out of
the top and refi t the other way up. The snap in
converter device is marked to show which gas it
is set for. Make sure the device is secure in the
top cap and refi t the cap to the regulator.
Stick on label
Stick the appropriate label on to the data badge
to indicate the gas the appliance is now set for.
The data badge is located under the Main oven.
Remove the plinth by pulling forward (it is held in
place by magnetic catches) and pull forward on
the sheet metal tag under the center of the oven
to swing out the badge plate.
Pressure Testing
Connect the appliance to the gas supply. Check
the appliance is gas sound.
The gas pressure can be measured at one
of the central cooktop burner orifi ces. Lift off
a burner head. Fit the pressure gauge to the
orifi ce. Turn on the cooktop burner and turn on
and light one of the other burners.
Reassemble burner top, making sure it is
reassembled in the correct way on the burner
body.
Refit the Flue grille assembly
Check the appliance is gas sound.
Check operation of all the burners.