Nikon AW120 User Manual
Page 240
F
10
T
e
chni
cal N
o
te
s
a
n
d I
n
dex
Camera turns off
without warning.
• The camera automatically turns off to save
power (auto off function).
• The camera or battery has become too cold
and cannot operate properly.
• The inside of the camera has become hot.
Leave the camera off until the inside of the
camera has cooled, and then try turning it
on again.
• The camera turns off if the USB cable
connecting it to a computer or printer is
disconnected. Reconnect the USB cable.
–
Monitor is blank.
• The camera is off.
• The camera has entered standby mode to
save power. Press the power switch,
shutter-release button, A button,
c
button, or
b (e movie-record) button.
• The flash lamp flashes while the flash is
charging. Wait for the flash to charge.
• The camera and computer are connected
via the USB cable.
• The camera and TV are connected via an
HDMI cable.
• Camera and smart device are connected
using Wi-Fi connection and the camera is
operated by remote control.
Monitor is hard to
read.
• Adjust the monitor brightness.
• The monitor is dirty. Clean the monitor.
Date and time of
recording are not
correct.
• If the camera clock has not been set, the
“Date not set” indicator flashes during
shooting and movie recording. Images and
movies saved before the clock is set are
dated “00/00/0000 00:00” or “01/01/2014
00:00” respectively. Set the correct time and
date from the Time zone and date option
in the setup menu.
• The camera clock is not as accurate as
ordinary watches or clocks. Periodically
compare the time of the camera clock with
that of a more accurate timepiece and reset
as required.
Problem
Cause/Solution
A