Troubleshooting, Display, settings and power supply – Nikon S550 User Manual
Page 146
134
T
e
chni
cal N
o
te
s
Troubleshooting
If the camera fails to function as expected, check the list of common problems
below before consulting your retailer or Nikon-authorized service representative.
Refer to the page numbers in the right-most column for more information.
Display, Settings and Power Supply
Problem
Cause/Solution
A
Monitor is blank
• Camera is off.
• Battery is exhausted.
• Standby mode for saving power: press the
shutter-release button halfway.
• When flash lamp blinks red, wait until flash
has charged.
• Camera and computer are connected via
Audio/Video/USB cable.
• Camera and TV are connected via Audio/
Video/USB cable.
• Time lapse or interval timer photography in
progress.
–
Monitor is hard to read
• Adjust monitor brightness.
• Monitor is dirty. Clean monitor.
• Monitor has dimmed to save power. Monitor
brightens when controls are used.
Camera turns off without
warning
• Battery is low.
• Camera has turned off automatically to save
power.
• Battery is cold.
Date and time of recording are
not correct
• Pictures recorded before clock was set, and
“Date not set” indicator blinks during shooting,
will have time stamp of “00/00/0000 00:00”;
movies and voice recordings will be dated “01/
03/2008 00:00.”
• Check camera clock regularly against more
accurate timepieces and reset as required.
No indicators displayed in
monitor
Hide info is selected for Photo info.
Select Show info.
Date imprint not available
Camera clock has not been set.
Date not appearing on pictures
even when Date imprint is
enabled
Date does not appear on movies or on pictures
taken using d, l, p or when Continuous is
set to Continuous or BSS.