Nikon Df - Manual (Page 375)

355
n
ISO sensitivity
(Recommended
Exposure Index) ISO 100 – 12800 in steps of 1 /
3
EV. Can also be set to
approx. 0.3, 0.7, or 1 EV (ISO 50 equivalent) below ISO
100 or to approx. 0.3, 0.7, 1, 2, 3, or 4 EV (ISO 204800
equivalent) above ISO 12800; auto ISO sensitivity
control available
Active D-Lighting Can be selected from Auto, Extra high +2/+1, High,
Normal, Low, or Off
Focus
Autofocus Nikon Multi-CAM 4800 autofocus sensor module with
TTL phase detection, fine-tuning, and 39 focus points
(including 9 cross-type sensors; the center 33 points are
available at apertures slower than f/5.6 and faster than
f/8, while the center 7 focus points are available at f/8)
Detection range –1 – +19 EV (ISO 100, 20 °C/68 °F)
Lens servo • Autofocus (AF): Single-servo AF (AF-S); continuous-servo
AF (AF-C); predictive focus tracking activated
automatically according to subject status
• Manual focus (M): Electronic rangefinder can be used
Focus point Can be selected from 39 or 11 focus points
AF-area mode Single-point AF; 9-, 21-, or 39-point dynamic-area AF,
3D-tracking, auto-area AF
Focus lock Focus can be locked by pressing shutter-release button
halfway (single-servo AF) or by pressing A AE-L/AF-L
button
Flash
Flash control TTL : i-TTL flash control using 2016-pixel RGB sensor is
available with SB-910, SB-900, SB-800, SB-700, SB-600,
SB-400, or SB-300; i-TTL balanced fill-flash for digital SLR
is used with matrix and center-weighted metering,
standard i-TTL flash for digital SLR with spot metering
Flash mode Front-curtain sync, slow sync, rear-curtain sync, red-eye
reduction, red-eye reduction with slow sync, slow rear-
curtain sync, Auto FP High-Speed Sync supported
Exposure