ROTHENBERGER ROWELD Aushebevorrichtungen P800B P1200/48B User Manual
Page 7
ENGLISH
5
Intended use
The lifting out device for ROWELD P800, P1200/48“B may only be mounted on the basic machine with
the appropriate static stability. The lifting out device is only to be used for insertion and lifting out of the
milling device and heating element in the basic machine and the adjusting box.
Technical data
no. 54253
no. 54176
Operating voltage ..................................380 – 415 V ................................ 400V
Mains frequency ....................................50 Hz .......................................... 50 Hz
Duty cycle ..............................................50% ............................................ 40%
Nominal output .....................................0,4 / 1,7 kW ................................ 0,2 / 0,85 kW
Nominal current .....................................2,2 / 4,8 A ................................... 1,9 / 2,2 A
Ambient temperature ............................-10 to +40 °C .............................. -20 to +40 °C
Housing Protection Class ........................IP 55 ............................................ IP 55
Noise emission .......................................LP at a distance of 3m 61 dB(A) ... LP at a distance of 1m 70 dB(A)
Payload ..................................................410kg .......................................... 250kg
Jib length ...............................................2000 mm..................................... 1500 mm
Swivel and move ....................................by hand ....................................... by hand
Overview
1
Lower section
7
Hexagonal screw M16x55
13 Hexagonal screw M24x60
2
Support foot
8
Washer B17
14 Washer B25
3
Articulated foot
9
Hexagonal nut M16
15 Hexagonal nut M24
4
Middle part
10
Groove nut
5
Upper part
11
Chain hoist
6
Radial arm
12
Chassis
Assembly (no. 54253)
Read and understand the attached product manual for the chain hoist and chassis!
Î
Fasten the lower section (1) with 8 hexagonal screws (7), 8 washers (8) and 8 hexagonal nuts (9) to
the feeder plate for the basic machine.
Î
Mount the support foot (2) with 4 hexagonal screws (7), 4 washers (8) and 4 hexagonal nuts (9) on
the lower section (1).
Î
Adjust the articulated foot (3) to the substrate appropriately.
Î
Fasten the middle section (4) with 4 hexagonal screws (7), 4 washers (8) and 4 hexagonal nuts (9) to
the reticular membrane of the bottom section (1).
Î
Mount the upper section (5) with the mounted radial arm (6), chassis (12) and connection cable with
4 hexagonal screws (7), 4 washers (8) and 4 hexagonal nuts (9) on the middle section (4).
Î
Open suspension bracket for chain hoist (11) through removal of an SL-retainer and pull out the bolt.
Î
Raise chain hoist (11) under the chassis (12), fold the suspension bracket over the chassis bolt, push
in bolt and secure with an SL-retainer.
Î
Insert the bayonet coupling of the connection cable into the connection of the chain hoist (11) an
indentation ensures that the coupling only fits in one position.