Roll rite, Installation – A.J. Antunes & Co RR-75 9300404 User Manual
Page 6
ROLL RITE
6
P/N 1011067 Rev. E 06/14
Safety Information
1. Plug the electrical cord into a certified electri-
cal outlet with a corresponding voltage rating as
listed on the machine model labels. Units with two
cords must be plugged into outlets on individual
branch circuits.
2. There is one motor in the units that have one on/
off switch.
3. There are two motors in units that have two on/
off switches. The left switch controls the rotation
of the front set of rollers and the right switch con-
trols the rotation of the rear set of rollers.
4. On units with two temperature controls, the left
dial controls the front half of the rollers which are
denoted by black bearings. The right dial controls
the rear rollers, which have white bearings.
5. Units with four temperature controls operate from
left to right across the front panel.
Switch #1 controls the heat in the front four rollers
1-4, which are designated by black bearings.
Switch #2 controls the heat in the next four rollers
5-8, which are designated by white bearings.
Switch #3 controls the heat in the next four rollers
9-12, which are designated by white bearings.
Switch #4 controls the heat in the next four rollers
13-16, which are designated by black bearings.
Unpacking
1. Remove unit and all packing materials from ship-
ping carton.
2. Open the large box. Remove all packing materi-
als and protective coverings from the unit and
parts.
NOTE: If any parts are missing or damaged,
contact Antunes Technical Service IMMEDIATELY
at 1-877-392-7854.
3. Wipe all surfaces of the unit with a hot, damp cloth.
NOTE: Do NOT use a dripping wet cloth. Wring out
before use.
Equipment Setup
When placing the unit into service, pay attention to the
following guidelines:
• Make sure power to the unit is off and the unit is
at room temperature.
INSTALLATION
CAUTION
All electrical connections must be in accordance
with local electrical codes and any other appli-
cable codes.
WARNING
ELECTRICAL SHOCK HAZARD. FAILURE TO
FOLLOW THE INSTRUCTIONS IN THIS MANUAL
COULD RESULT IN SERIOUS INJURY OR DEATH.
• Electrical ground is required on this appliance.
• Do NOT modify the power supply cord plug. If
it does not fit the outlet, have a proper outlet
installed by a qualified electrician.
• Do NOT use an extension cord with this
appliance.
• Check with a qualified electrician if you are
unsure if the appliance is properly grounded.
• Do NOT block or cover any openings on the unit.
• Do NOT immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do NOT allow cord to hang over edge of table or
counter.
• Place unit on a sturdy, level table or work surface.
• Ensure that the line voltage corresponds to the
stated voltage on the unit specification label.
•
Do NOT use an extension cord with this appliance.
Preparation
1. Set the unit on a flat surface.
2. Position the unit near the power outlet. Avoid the
use of extension cords.
3. Clean unit thoroughly before use.
4. If unit fails to operate properly
when first
installed, call Antunes Technical Service at 1-877-
392-7854.
Electrical
Refer to the product tag on the serial plate on the back
of the unit for voltage and wattage requirements. Be
sure to plug the unit into an outlet with sufficient power.