A.J. Antunes & Co RR-75 9300404 - Manual (Page 8)

ROLL RITE
8 P/N 1011067 Rev. E 06/14
MAINTENANCE
WARNING
Turn the power off, unplug the power cord, and
allow the unit to cool down before performing any
service or maintenance.
Cleaning
1. Set the Temperature Controls to high and turn all
rollers on.
NOTE: Always start at the end of the rollers and
wipe towards the center.
2. Use a soft cloth to wipe the rollers clean.
3. If the buildup on the rollers can not be removed
by wiping with a wet cloth, wrap some ice cubes
in a soft towel and rub over the rollers.
NOTE: Do NOT use any metal objects on the rollers
as they could cause serious damage.
4. Remove the drip pan and clean with mild soap
and water.
Replacing the Motor
1. Unplug the power cord and allow the unit to cool.
2. Remove the end cover from the motor side.
NOTE: On single motor units, the motor is on the
left. On dual motor units, there is a motor on each
side. The left drives the front rollers and the right
drives the rear rollers.
3. Disconnect the chain from the motor sprocket and
remove the motor sprocket from the motor.
4. Turn the unit over and remove the bottom cover.
5. Disconnect the motor wires and remove the
motor screws.
6. Remove the motor and replace with the new
motor.
7. Insert the motor screws and connect the motor
wires to the new motor.
8. Reassemble the unit, plug in the power cord, and
test before returning to service.
Replacing the Thermostat
1. Unplug the power cord and allow the unit to cool.
2. Remove the knobs and drip pan.
3. Turn the unit over and remove the bottom cover.
4. Loosen the nuts or screws holding the thermostat
in place.
5. Disconnect the wires from the thermostat.
6. Remove the thermostat and replace with the new
thermostat.
7. Reconnect the wires.
8. Reassemble the unit, plug in the power cord, and
test before returning to service.