A.J. Antunes & Co MS-255 9100468 - Manual (Page 4)

Miracle SteaMer
4 P/N 1010455 Rev. D 03/12
A.J. Antunes & Co.
in addition to the warnings and cautions in this manual,
use the following guidelines to safely operate the unit.
• Read all instructions before using equipment.
• For your safety, the equipment is furnished with
a properly grounded cord connector. Do NOt
attempt to defeat the grounded connector.
• Install or locate the equipment only for its intend-
ed use as described in this manual. Do NOt use
corrosive chemicals in this equipment.
• Do NOT operate this equipment if it has a dam-
aged cord or plug, if it is not working properly, or
if it has been damaged or dropped.
• This equipment should be serviced by qualified
personnel only. contact the nearest authorized
service agency for service.
• Do NOT block or cover any openings on the unit.
• Do NOT immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do NOT allow cord to hang over edge of table or
counter.
the following warnings and cautions appear
throughout this manual and should be carefully
observed:
• Turn the power off, unplug the power cord,
and allow the unit to cool down before per-
forming any service or maintenance.
• The equipment should be grounded accord-
ing to local electrical codes to prevent the
possibility of electrical shock. it requires a
grounded receptacle with separate electrical
lines, protected by fuses or a circuit breaker
of the proper rating.
• All electrical connections must be in accor-
dance with local electrical codes and any
other applicable codes.
• warninG electrical shOcK hazarD.
failUre tO fOllOw these instrUctiOns
cOUlD resUlt in seriOUs inJUrY Or
Death.
- electrical ground is required on this unit.
- Do nOt modify the power supply cord plug.
if it does not fit the outlet, have a proper
outlet installed by a qualified electrician.
- Do nOt use an extension cord with this
appliance.
- check with a qualified electrician if you are
unsure if the unit is properly grounded.
• This equipment is to be installed to com-
ply with the basic plumbing code of the
building Officials and code administrators,
inc. (bOca) and the food service sanitation
manual of the food and Drug administration
(fDa).
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent, or a similarly qualified person.
• Do NOT clean this appliance with a water jet.
• Do NOT use a sanitizing solution or abrasive
materials. the use of these may cause dam-
age to the stainless steel finish.
• To ensure proper steaming characteristics,
some calcium/mineral deposits must be pres-
ent on the Generator surface. if, during clean-
ing, the surface does become free of calcium/
mineral deposits, one approved method is to
add plain tap water to the surface and allow
it to boil off. this will ensure proper steam-
ing characteristics by creating a thin layer of
deposits on the surface.
• chlorides or phosphates in cleaning agents
(such as bleach, sanitizers, degreasers, or
detergents) could cause permanent damage
to stainless steel equipment. the damage is
usually in the form of discoloration, dulling
of metal surface finish, pits, voids, holes, or
cracks. this damage is permanent and not
covered by warranty.
• The following tips are recommended for main-
tenance of your stainless steel equipment,
- always use a soft, damp cloth for cleaning,
rinse with clear water, and wipe dry. when
required, always rub in direction of metal
polish lines.
- routine cleaning should be done daily
using soap, ammonia detergent, and water.
- stains and spots should be removed using
a vinegar solution.
- finger marks and smears should be
rubbed off using soap and water.
- hard water spots should be removed using
a vinegar solution.
impOrtant safetY infOrmatiOn (continued)