A.J. Antunes & Co UFL-440 9700479 - Manual (Page 3)

UFL-420/440 water FiLtration system
3 P/N 1010873 Rev. G 03/12
A.J. Antunes & Co.
Suggested replacement period for Cartridge is approxi-
mately 3 years.
For sales in the state of Iowa:
Seller: Date:
Buyer: Date:
ImpOrtant safety InfOrmatIOn
In addition to the warnings and cautions in this manual,
use the following guidelines for safe operation of the unit.
• Read all instructions before using equipment.
• Install or locate the equipment only for its intended
use as described in this manual. Do not use corro-
sive chemicals in this equipment.
• Do not operate this equipment if it has a damaged
cord or plug; if it is not working properly, or if it has
been damaged or dropped.
• This equipment should be serviced by quali-
fied personnel only. Contact Antunes Filtration
Technologies for repair.
• Do not immerse cord or plug in water.
• Keep cord away from heated surfaces.
The following warnings and cautions appear throughout
this manual and should be carefully observed.
• Disconnect the power source before performing any
service or maintenance on the unit.
• All electrical connections must be in accordance
with local electrical codes and any other applicable
codes.
• WARNINg eLecTRIcAL ShocK hAzARD.
FAILURE To FoLLoW THESE INSTRUCTIoNS
CoULD RESULT IN SERIoUS INJURY oR DEATH.
service/technical assistance
If you experience any problems with the installation
or operation of your unit, contact Antunes Filtration
Technologies at 1-630-784-1000, or toll free in the
United States at 1-800-253-2991.
Fill in the information in the next column and have it
handy when calling for assistance. The serial number
is on the specification plate located on the unit.
Purchased From:
Date of Purchase:
Model No.:
Serial No.:
Mfg. No.:
Owner InfOrmatIOn (continued)
ImpOrtant
a.J. antunes and company reserves the right to change specifications and product design with-
out notice. such revisions do not entitle the buyer to corresponding changes, improvements,
additions or replacements for previously purchased equipment.
- Do not modify the power supply cord plug. If
it does not fit the outlet, have a proper outlet
installed by a qualified electrician.
- Do not use an extension cord with this appli-
ance.
• If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a simi-
larly qualified person.
• This equipment is to be installed to comply with the
local plumbing code and any other applicable code.
• Water pressure must not exceed 100 psig (690
kPa). To reduce water pressure, install a water
pressure regulator and set water pressure to suit
application. Note that trans membrane pressure
(inlet water pressure minus the permeate water
pressure) must not exceed 45 psi (310 kPa).
• System should be supplied only with cold water.
• commonwealth of Massachusetts Plumbing code
248 cMR shall be adhered to. The use of saddle
valves are not permitted, please consult your local
plumber.
• A ground fault circuit interrupter (gFcI) must be
installed on the circuit to this system
• When installed on metallic plumbing, a properly
sized electrical bonding jumper must be installed
across the inlet and outlet pipes serving this device.